Composite Door Designer
Design the door that's right for you, choose from thousands of designs.
We make it easy for you to choose the exact door you want.

Design your own Door

Measuring Guides

Door Panel Measuring in UPVC Doors

Width

The width should be measured overall outside edge of the bead at two points – top and bottom of the opening.  The smallest of these measurements is taken as the width. Then deduct 10mm from this width measurement to allow for packing and Toe and Heeling

Height

The Height should be measured overall outside edge of the bead at two points – top and bottom of the opening.  The smallest of these measurements is taken as the height. Then deduct 10mm from this height measurement to allow for packing and Toe and Heeling

Measuring the Thickness of your Panel


Click Picture to enlarge

Letterbox in Panel?

If your Panel has a Letterbox in then the quickest and easiest way to measure the Thickness is to remove the inside and outside parts of the letterbox and this will give you clear access to measure your panel.
 

Removal of the beads

Glazing Knife or Pallet Knife only needs to bet apped in about 2mm so the bead can be prized out 




*Due to the nature of materials used and the method of manufacture of panels, there is a tolerance of + or – 3mm to the cut size and + or - 1.5mm to the thickness of every infill panel. A 10mm allowance on the aperture opening should be allowed.